Panasonic air conditioner split wall PKEA CS-E15PKEA 4.2KW server air-con
Description
Cooling rooms containing electronics is particularly important where: The air conditioning devices used for cooling have to be reliable and also provide the necessary cooling capacity when outdoor temperatures are very low. Environmental aspects must also not be overlooked. The PKEA ...
Cooling rooms containing electronics is particularly important where: The air conditioning devices used for cooling have to be reliable and also provide the necessary cooling capacity when outdoor temperatures are very low. Environmental aspects must also not be overlooked. The PKEA wall-mounted inverter air conditioning units from Panasonic thoroughly meet these requirements.
Separately available interface accessory for controlling the climate in IT rooms
PAW-SERVER-PKEA: Redundancy control interface and switchover on fault for 2 PKEA interior units in IT rooms, fault alerts via isolated contacts.
Features
- Year round cooling mode operation down to -15 °C
- Optimum effectiveness even with very low outdoor temperatures
- Low resistance anti-friction bearing
- Additional pipe temperature sensor for frost protection
- The devices can be used with existing R22 refrigerant lines
- Option to integrate the devices ...
- Year round cooling mode operation down to -15 °C
- Optimum effectiveness even with very low outdoor temperatures
- Low resistance anti-friction bearing
- Additional pipe temperature sensor for frost protection
- The devices can be used with existing R22 refrigerant lines
- Option to integrate the devices into the Panasonic P-Link communication bus for VRF and PACi devices using P-Link adapter CZ-CAPRA1
Accessories / Replacement parts
-
Communication
-
Control via internet
-
Redundancy circuit
-
Remote controls
Technical data
(Niedrig/Mittel/Hoch)
(Niedrig/Mittel/Hoch)
Notes
1) At an outdoor temperature of 30 °C and a room temperature of 19.5 °C WB.
2) The annual power consumption is based on the standards ErP Directive.
3) Measurement locations: Indoor unit: 1 m in front of and 80 cm below the unit; outdoor unit: 1 m in front of the device at a height of 1.5 m. The measured values are based on EUROVENT document 6/C/006-97.
4) 70 mm need to be added for pipe connections.
5) Energy efficiency scale from A+++ to D.