Pego control box electronic 400V ECP Plus R300 Expert VD7 with datalogger
More in this category: With logging
One click to the most important information:
Description
The ECP Plus R300 Expert series (successor of the ECP Plus 300 Expert) is a microprocessor controlled cooling system controller for regulating room temperature and evaporator fan. The cooling system controller features six independent relay outputs, one each for the compressor, evaporator fan, ...
The ECP Plus R300 Expert series (successor of the ECP Plus 300 Expert) is a microprocessor controlled cooling system controller for regulating room temperature and evaporator fan. The cooling system controller features six independent relay outputs, one each for the compressor, evaporator fan, defrosting heater, condenser fan, alarm output and room lighting. The ECP R300 Expert cooling system controller also features three isolated input contacts (door contact switch, complete motor protection compressor protection) that can be configured.
A data recording system is also integrated in this control system, which stores your measurement data. If necessary, these can be loaded on an SSD card and downloaded to a PC.
Features:
1 pcs. control board with display and keyboard for operating elements
1 pcs. motor protection switch, circuit breaker
3 pcs NTC sensor 10K (25 °C)
Fittings for tension relief and line entry
Motor protection switch must be ordered separately (see selection table).
Features
Directly controls the compressor, evaporator fan, defrosting heater, condenser fan, room lighting and
alarm output
Control unit with Pego design
Compact self-extinguishing ABS plastic housing with IP65 protection rating
Status message and alarm notifications are shown via LED
Three NTC sensors ...
Directly controls the compressor, evaporator fan, defrosting heater, condenser fan, room lighting and
alarm output
Control unit with Pego design
Compact self-extinguishing ABS plastic housing with IP65 protection rating
Status message and alarm notifications are shown via LED
Three NTC sensors are included
Isolating transformer / control transformer
Power unit wired in
Ausstattung
- 1 Stk Steuerplatine mit Display und Tastatur für Bedienungselemente
- 1 Stk Motorschutzschalter, Leitungsschutzschalter
- 3 Stk NTC Fühler 10K (25 °C)
- Verschraubungen zur Zugentlastung und Leistungseinführung
Accessories / Replacement parts
-
Auxiliary contact
-
Motor protection
-
Pufferbatterie