Euro Line power rack set ECO Rack R134a EV2B-ER-2JES-07 Y

Schiessl Euro Line power racks operate with 2, 3 or 4 semi-hermetic Bitzer Octagon compressors with the same cooling power. Cooling power is regulated depending on the intake pressure. To control the power rack, a power rack controller is used in combination with a pressure transmitter. This is mounted and thermally decoupled on the intake side and records the actual intake pressure value. The power rack controller regulates the cooling power of the rack so that the target value is achieved as closely as possible. The rack controller is optionally available with the control box.

Also available is the slightly simpler XC650CX regulator from Dixell for operation without power regulation (also with power regulators for EV2B-ER) and the XC 660D and XC 1008D for operation with power regulators. Other types on request. Control boxes are available as accessories for mounting externally. All components are built with a tough riveted steel profile frame. All parts of the frame are powder-coated. The power rack stands on the supplied rubber-bonded metal base. The power rack must be horizontally oriented using a spirit level before commissioning. Matching collector stations are available as accessories for the power racks. Oil supply to the compressors is provided by a high pressure oil regulation system with electronic oil regulators. Using the accessories available, the system can be adjusted to the required specification on site.

• optimally adapt compressor performance to changing loads on the refrigeration system
• low minimum cooling power
• optimal temperature and quality for refrigerated goods
• minimal space needed due to compact design
• energy saving from better performance control in optimal evaporating temperatures
• standard components mean it is easy to service
• reduce the installed cooling power and thus the cost of investment by use of coincidence factor
• simple installation of a heat recovery systems using a common heat exchanger for all areas to be cooled

• 2, 3 or 4 semi-hermetic Bitzer Octagon compressors
• crankcase heater
• high pressure monitor for each compressor, type tested (cartridge design, fixed configuration)
• low pressure monitor, type tested
• pressure transmitter, intake pressure -0.5 to 7 bar
• oil separator with integrated oil reservoir
• oil supply line with oil filter
• electronic oil regulator for each compressor
• optimised intake collection piece, insulated